By following these steps, you'll be able to effectively update your DrumLink Hub using the DWe Control software.
-
Access the Hub Config Panel:
1. Open the DWe Control software on your computer.
2. Locate and click on the "HUB" button within the software. This action will open the Hub Config Panel, where you can manage your DrumLink Hub's settings.
-
Check for Updates:
Within the Hub Config Panel, look for the section displaying "Firmware Revision."
If an "Update" button is visible next to the Firmware Revision information, this indicates that there's a new firmware update available for your DrumLink Hub.
-
Initiate the Update:
Click on the "Update" button if it's present.
Wait patiently while the update is uploaded and installed onto your DrumLink Hub.
The software will provide feedback on the progress of the update.
-
Update Confirmation:
After the update process is complete, the Hub Config Panel will likely indicate the successful update or display the new firmware revision number. If, instead of an "Update" button, you see a "Revert" button next to the Firmware Revision information, this means that the DrumLink Hub is already updated to the latest version.
-
Close the Hub Config Panel:
Once you've confirmed the update or found that the Hub is already updated, click the "CLOSE" button within the Hub Config Panel to exit the configuration interface.